1. According to the host model, select the lens and radar to divide into two lines, connect the host, lens and radar respectively (when not connected to the radar, wrap its interface with tape)
2. The lens is generally installed in the middle position below the license plate at the rear of the car, and the height is confirmed according to different models.
3. After selecting a suitable drill according to the size of the lens diameter to open the rear of the car, use the angle adjustment nut and fix the lens. Pay attention to the direction of lens installation (white point upward), otherwise the reverse image will not be correct.
4. The reversing wiring is roughly the same as that of the disc box. After connecting to the host, it is routed through the auxiliary driver's debris box, and then to the rear seat of the car through the right side car waterproof plate, and then to the tail box. After passing through the tail box, it can be directly connected to the reversing camera. on.
5. To install the reversing lens, connect the reversing line of the car to the reversing control line on the host. (When reversing, the car’s reversing line outputs 12V voltage, and insulation protection must be done when the reversing lens is not connected.) When searching for the car’s reversing line, a reversing control line on the host is connected to the rear of the car and connected to the reversing taillight. You can also find the reversing line on the dashboard or steering wheel, and connect it to the host reversing control line. The joints of the connecting part are covered with electrical tape to prevent loosening.
6. After the installation is complete, shift to the car gear, that is, switch to the reverse image, and switch to the original state after shifting the gear.